MULTIPLEX MULTIswitch FLEXX Operations Instructions download pdf (Page 7)

Operating Instructions

MULTIswitch FLEXX

MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de Page 3/4

Operating Instructions for MULTIswitch FLEXX • Errors and omissions excepted. •



MULTIPLEX

6 SETTINGS

6.1 Settings for SMART SX FLEXX remote control

The factory settings of the MULTIswitch FLEXX are

selected so that the three switching channels can be

operated using the SMART SX FLEXX transmitter.

Switching

channel

Actuator in the

SMART SX FLEXX

transmitter

Function

1 Left vertical rocker

switch

on / off

2 Right vertical rocker

switch

on / off

3 Left stick button Press button

to switch on /

off

6.2 Assignment of free servo channels

If you are using a remote control with freely assignable

servo channels, you can control the MULTIswitch FLEXX

with the factory settings as follows:

Servo

channel

MULTIswitch FLEXX switching

channel

5 1

6 2

7 3

6.3 Settings using MULTIPLEX Launcher

You can customize MULTIswitch FLEXX according to

your requirements using the free MULTIPLEX Launcher

PC software.

The MULTIPLEX Launcher PC software is available at

http://www.multiplexrc.de.

You need the following accessories to connect to a PC:

• MULTIPLEX PC USB adapter #85149

You can specify the following settings for each switching

channel:

• Servo channel

• Switching threshold and direction

• Type of switching function

• Load control: Duration, blink mode, flash mode

Figure 5 Windows software MULTIPLEX Launcher

7 ERRORS AND SOLUTIONS:

Problem:

MULTIswitch FLEXX is not receiving any data via the

SRXL cable (the LED remains off).

Possible causes and solutions:

• MULTIswitch FLEXX must be restarted (e.g. after

operation on the PC): Disconnect the supply voltage

and reconnect it.

• If you are using a MULTIPLEX telemetry receiver, the

SRXL output must be activated first on the receiver

(e.g. using the MULTIPLEX PC USB adapter #85149

and MULTIPLEX Launcher or using #82094

MULTImate).

Problem:

The LED for receiving data lights up, but no power is

being supplied to the loads.

Possible causes and solutions:

• Jumper U(Bat) is disconnected.

• No voltage source is connected to the terminal U(Bat).

• The servo assignment on the remote control

transmitter does not match the settings in the

MULTIswitch FLEX.

8 ACCESSORIES

MULTIPLEX PC USB adapter

#85149

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comments to this Manuals

No comments

MULTIPLEX MULTIswitch FLEXX Operations Instructions Page 7

Comments to this Manuals

Related products and manuals for Toy parts MULTIPLEX MULTIswitch FLEXX